EDM Product 08766 Manual De Instrucciones página 25

Angle grinder
Operation
• Fit the desired disc on the spindle and replace the outer
flange and backing flange. Release the spindle lock.
WARNING: Important! Only ever press the spindle lock
when the motor and grinding spindle are at a standstill
You must keep the spindle lock pressed while you change
the wheel !
For grinding wheels up to approx. 3 mm thick, screw on the
flange nut with the flat side facing the grinding wheel.
Fig. 5
Switching on / off
WARNING: Before engage on the ON/OFF switch button,
check that the grinding disc is properly fitted and run
smoothly, the outer flange is well tightened.
• Connect the battery pack onto the angle grinder body.
• The machine can only be started by depressing the on/off
switch left, then push the switch up,you can start the
machine
• Press down the front part of the switch, the on/off switch
can be locked in on position (1 position) for continuous
grinding
• Press rear part of the switch, the tool will turns off.
• Do not let go of grinder until it has stopped running.
WARNING: The wheel continues to rotate after the tool is
switched off.
Fig. 6
Grinding (Fig.7)
Hold the handle (3) and auxiliary handle (4) firmly and
switch on. Avoid blocking the ventilation slots with your
hand, as this may cause the grinder to overheat. Let the disc
reach full speed. Apply the grinder to the item. Maximum
effect is achieved when the grinder is held at an angle of
15-30°in relation to the item.
Move the grinder gently along the item. Give the grinder
time to work. It is rarely necessary to press the disc hard
against the surface to be worked. Sparks can occur in the
motor compartment during use. This is normal and does
not mean the grinder is defective. Switch off the grinder
after use.
Flange arrangements (Fig.8)
Flange arrangements when using a depressed centre or
EN INSTRUCTION MANUAL
a
b
straight grinding wheel. (Fig.10)
Fig. 7
Fig. 8
Service & maintenance
Always remove the battery from the tool before performing
any adjustment or maintenance operation.
Take care not to expose this tool to rain.
Keep the ventilation openings clear and clean the product
regularly.
Repair of the tool must only be carried out by a qualified
repair technician.
Repair or maintenance by unqualified personnel can lead
to a risk of injury.
Use only identical spare parts for repairing a tool
Cleaning
Avoid using solvents when cleaning plastic parts. Most
plastic parts are susceptible to damage from various
types of commercial solvents and may be damaged by their
use. Use clean clothes to remove dirt, carbon
dust, etc.
Storing
Store the machine, operating instructions and where
necessary the accessories in the original packaging. In this
way you will always have all the information and parts ready
to hand.
Pack the device well or use the original packaging in order
to avoid transit damage.
Always keep the machine in dry place.
REF. 08766
15-30°