EDM Product 08766 Manual De Instrucciones página 24

Angle grinder
Operation
Before use
• Remove any packing material and loose parts from unit.
• Check the accessories before use. It should be fit with the
machine and your purpose.
• If the machine is new, the battery must first be charged.
Attention! After long time storage, the battery capacity will
be reduce.
A new battery or one which has not been used for an
extended period achieves full performance only after
charging and discharging cycles. A substantial drop in
operating period per charge indicates that the battery is
worn out and must be replaced.
Battery charger (Fig.1)
The lithium-ion battery can be charged at any time and will
not develop a "memory" when charged after only a partial
discharge. It is not necessary to run down the battery pack
charge before recharging. Remove the battery pack from
the tool when convenient for you and your job. You can
"top-off" your battery pack's charge before starting a big job
or long period of use.
Due to lithium-ion's fade-free properties, the only time it is
necessary to charge the lithium-ion battery pack is when
the pack has reached the end of its charge. To signal the
end of charge, power to the tool will drop quickly. Charge
the battery pack as needed.
Fig. 1
Charging the battery
This lithium-ion battery pack is shipped partially charged.
Before using it the first time, fully charge the battery pack. A
fully discharged battery pack with a temperature between
0°C and 40°C will be charged in about 2 hours.
• Charge the lithium-ion battery pack only with the correct
charger.
• Connect the charger to a power supply.
• Insert the battery pack into the charger, making sure the
battery pack is fully seated.
• The charger will communicate with the battery pack to
evaluate the condition of the battery pack.
• The red lights on while the battery pack is charging. After
charging is complete, the green LED on the charger will be
on.
• After approximately 2h, battery is fully charged.
• Unplug the charger, and then remove the battery pack.
WARNING: Never use a damaged battery pack.
WARNING: Always disconnect the charger from the power
source when it is not in use.
WARNING:
• The charger supplied is matched to the Li-ion battery
installed in the machine. Do not use another charger.
• This cordless angle grinder has integrated overcharge
protection, when the battery cell is overcharged, the
overcharge protection will operate to stop charging the
battery.
• During the charging procedure, the battery will heat up;
this is normal.
EN INSTRUCTION MANUAL
Insertion and removal of rechargeable battery (Fig.2)
Depress the battery-release button located on the front of
the battery pack to release battery pack.
Pull the battery pack out and remove it from the tool.
Fig. 2
Fitting the auxiliary handle (Fig. 3)
The auxiliary handle (4) can be attached to the angle
grinder in 3 different positions: left, right and top.
Fig. 3
Disc Guard (Fig.4)
CAUTION! The machine should be used only with guard.
The position of the disc guard can be adjusted to suite the
working conditions. To do this, please follow below steps:
• Pull the quick clamping head
• Turn the guard to the desired position
• Press the quick clamping head
Fig. 4
Replacing the grinding disc (Fig.5)
WARNING: Beware that a disc which has been used may be
very hot!
• Depress and hold down the spindle lock button (1) to
secure the spindle.
• Turn the shaft until it locks.
• Remove the outer flange (a) and backing flange (b) by
using the two-hole spanner (9) provided.
REF. 08766