Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1. Attach the End Caps
Locate the spacer blocks and hardware bag.
Use masking tape to secure the spacer blocks to the outside of the
cabinets. Make sure the pilot holes line up with the recommended
holes in the mirror cabinet.
Position the end caps so the beveled edges are toward the mirror
and the front of the cabinet. Align the end caps so they are
centered to the mirror height. The end caps should be flush with
the back of the cabinet. Hold or clamp carefully (protect the
surface if clamping) until the attachment screws are in place.
Partially drive four #10 x 1-1/4" screws (provided) through the
inside location holes, through the spacer block holes, and into the
end caps. Tighten the screws to secure the end caps.
Install the dome cap covers over the screw heads.
1012595-2-A
8
Kohler Co.
Tabla de contenido
