Kenmore 116.31195 Manual De Uso página 21

1. Loop new bett around Carpet/Bare
Floor selector shaft and agitator belt
groove. Make sure belt is routed in the
belt guide as shown. See illustration for
correct belt routing.
Carpet/Bare
Floor Selector
S
2. Reinstall agitator back into nozzle by
placing end caps into grooves.
End Cap
Groove
3. After reinstalling the agitator, turn it
by hand to make sure that belt is not
twisted or pinched and that all rotating
parts turn freely.
4. Place the vacuum cleaner in the
upright position standing on the handle.
This will minimize wheel interference
when installing lower plate.
5. Reinstall lower plate by (1) aligning
tabs on front edge of lower plate with
slots in the nozzle and (2) rotating to
installed position.
6. Lay vacuum cleaner on the floor with
the bottom up and nozzle flat.
7. Install the four screws to the nozzle
covet
Four
8. Route nozzle hose to hose holder.
Align nozzle hose bracket with retaining
bracket on body and slide down unit it
clicks into place.
9. Return the vacuum cleaner to the
upright position before plugging into an
electrical outlet.
- 21 -