Removalfrom Window - Kenmore 580.73069 Manual Del Propietário

D IF AIR CONDITIONER IS BLOCKED BY
STORM WINDOW FRAME
• If storm window presents interference, fasten a
2"(51mm) wide wood stripto the inner window sill
across the full width of the sill.The wood strip should
be thick enough to raise the height of the window sill
so that the unitcan be installedwithoutinterference
from the the storm windowframe. See FIG. 10.
Top of wood stdp shouldbe approximately
3/4"(19mm) higher than the stormwindow frame to
help condensation to drain properly to the outside.
• Install a second wood stdp (approximately
6"(152mm) tong by 11/2"(38mm)wide and same
thickness as first strip) in the center of the outer sill
flush against the back of the inner sill. (FIG. 10)
11/2" rain. 3/4"(19mm)
WOOD STRIP MOUNTED (38mm) CLEARANCE
ONTOnOF,N ,LL STOnM
W,NWW *
% FRAME
);S]_RIP/
,o, OUTER
_ SILL
,
o o,ooo.
When storn_ window
frame is located on outer sill
FIG. 10
I_ INSTALLATION FOR OTHER TYPE
WINDOWS.
• Dimensions and geometry of windows are different
according to manufacturers. Check your window
and refer to FIG.11 to install the support bracket
firmly.
(a) When window frame Is located on inner sill.
• Installa woodstrip(windowwidth longand
windowframe heighthigh) onthe innersill.
SASH WINDOW --_
WINDOW FRAME i
WOOD STRIP_
INNER
SILL
OUTDOOR
(b) Whenthe windowframe is higherthan
19/32"(15mm)
• Install a wood strip(about4"(102mm) long) on the
outdoor sill to raise support bracket.
;TRIP
19/32"
SILL
OUTDOOR
SILL
FIG. 11
REMOVAL FROM WINDOW
• Turn off and unplugthe air conditioner.
• Unscrew the side screwsthat you installed in Step 5. 6.
• Close the curtain frame and remove foam seal and L
bracket from the windows.
• Keep a firm grip on the air conditioner raise the sash.
• Lift the air conditioner from the window and remove the
foam strip from between the windows.
• Remove the support bracket from window frame.
NOTE: When cooling season is over, unit is removed
from window for cleaning and storage. There may still be
some condensation water in the basepan. Remove the
unit carefully to avoid water being spilled out on floor,
always store unit flat on its base. Do not stand on end. Be
sure to remove support bracket, L bracket, and foam seal
from window and save. Window will not close if support
bracket remains installed.
• Airconditioners coveredin this manualpose an
excessive weight hazard. Two or morepeople
are needed to move and install the unit.
To preventinjury or strain, use proper lifting and
carrying techniques when moving unit.
• When handling the air conditioner, be careful to
avoid cuts from sharp metal fins on front and
rear coils.
• Make sure air conditioner does not fall during
removal.
-8-