How To Install - Kenmore 580.73069 Manual Del Propietário

INSTALLATION
To avoidthe possibiity of personalinjury,unplug
powerto unitbeforeinstalling or servicing.
Carefully remove air conditioner from carton, check
for possible shipping damage. Pick a location which
will allow you to blow the cold air into the area you
want. Windows used for installation must be strong
enough to support the weight of the air conditioner.
Good instanation with special attention to the proper
position of the unit will lessen the chance that
service will be needed.
When cooling more than one room, installation
location is very important. To cool your rooms, cold
air must be blown from the air conditioner in a
straight path.
If air conditioner is blocked by a storm window
frame, see Step 7 and 8 on Page 8 before
beginning to install.
HOW TO INSTALL
IIcut the FOAM STRIP (ITEM G) to fit the
underside of the window sash. Open the window,
peel off the backing and attach the FOAM STRIP as
shown in FIG. 3.
(ITEM G)
FIG. 3
_'_ Mark center line with pencil on the center of the
inner sill, as shown in FIG. 4
INDO0 _1_1__
CENTER LINE
INNER SILL
FIG. 4
_1 Install support bracket on window. See FIG. 5.
Install leveling bolt up through bottom side of support
bracket. You can choose a short bolt(ITEM C) or a
long one (ITEM B) accordingto windowtype. Also, you
should select the positionof hole on bracket.
Positionbracket on sill 1 inch(25.4mm) to left of
center line of window (See FIG. 5).
Fasten bracket loosely to sill with screws (ITEM D)
provided.
Adjust leveling bolt so that the air conditionerwill be
installed with a very slight tilt (about 1/4") downward
toward the outside for proper drainage. Tighten
bracket screws.
SILL
WINDOW
SILL
1'(25 4rnn
"CENTER LINE
OF WINDOW
/
ADJUSTMENT SLOT
'C)
FIG. 5
SCREW SUPPORT
INNER SILL BRACKET ABOUT 1/4"
FIG. 6
INDOOR
1
Failure to securely install support bracket may /
result in unit falling from window if window sash is
/
raised after unit is installed. This could result in
personal injury.
-6-