Lista De Acessórios; Troubleshooting - Guarany 405-11 Manual Del Operador

MANUAL DO OPERADOR | Pulverizadores Costais Simétricos SP
8. LISTA DE ACESSÓRIOS
U9888.00.00
4 Bicos: U9898.00.00
6 Bicos: U4288.00.00
Barra Universal Kit dosador
200 mm: K9798.00.00 U4575.00.00
400 mm: K9895.00.00
500 mm: K9960.00.00
Dosador Universal de Líquidos Chapéu de Napoleão
Com tubo aplicador: U8018.00.00 U7860.00.00
Sem tubo aplicador: U8096.00.00
08
U9537.00.00 U9767.00.00
U4750.00.00 U4222.00.00
Regulador de Vazão com Manômetro
0,9m: K4281.00.00 U9634.00.00
1,2m: K4280.00.00
4. SPRAY MAINTENANCE
!
Never leave the remains of agrochemicals in the spray tank; wash your sprayer
with clean water at the end of every workday, fill the tank to about 25% of its
volume with water and then spray for about 1 minute, into the an appropriate
container, allowing for thorough cleaning of the equipment. Follow this with the
lubrication procedure:
!
Double bushing lubrication (Figure 8): For lubrication of the dual bushing
(item 16) you should first remove the clip and then remove the upper part of the
lever pump rod (Figure 5 C), unscrew the pump-securing cap (item 7) and
withdraw the mixer (item 29) fixed into the pressure cylinder (item 20) inside the
chemical tank (for this you must use PPE (Personal Protection Equipment) and
proper gloves to avoid contamination). Remove the pressure cylinder (item 25)
and coat the inner wall with grease or Vaseline to allow lubrication of the dual
bushing when in operation.
!
Lubrication of Super 3 discharge valve (Figure 9): Disengage the items (G)
and (F) (Figure 6) and through one of the apertures add 3 drops of two-stroke
engine oil into item (F) (Figure 6) allowing the lubrication of the entire needle valve
assembly (item 44)
5. TROUBLE SHOOTING
TROUBLE
Lack of pressure in the pump Dirt in the lower valve (item 14) or wear of
this component.
Dual bushing (item 16)
Leakage of liquid from top of the Filling above the maximum level
Tank lid (item 3) - damaged/loose
equipment
Pump-securing cap (item 7)/gasket (item 6) - Damaged/loose
Cap valve (item 4)
Lever arm stiff Suction tube (item 26) - damaged/Loose
Note: Before mounting the suction tube, remove the product
from the inside of the tank and pressure cylinder holder (item 24).
Lower Valve (item 14) - Damaged/Dirty.
Lever arm loose lower valves (item 14) and dual bushing (item 16).
Dripping from adjustment point Lance seal (item 43) - Damaged
Air in the line
Discharge needle valve assembly (item 44) - jammed
Figure 8
Figure 9
THE CAUSE
SOLUTION
Cleaning/Replacing
Change
Fill only up to the maximum level indicated
Change/Tighten
Change/Tighten
Tighten
Change/Adjust
Change/Clean
Change
Change
Spray upwards for a few seconds
Change/Grease
21