11. TROUBLESHOOTING
PROBLEM
The booster won't jump start
my car.
The booster won't power my
12V device.
The battery in the booster won't
hold a charge.
12. SPECIFICATIONS
V
12V
AGM
TEST
13. REPLACEMENT PARTS
Wall Charger (EU) ..............................................................................................................................94065021
Wall Charger (UK) ..............................................................................................................................94065022
Wall Charger (Australia) .....................................................................................................................94065023
Fuse (300A) ...................................................................................................................................3999002113
POSSIBLE CAUSE
Clips are not making a good connection
to the battery.
The booster battery is not charged.
The vehicle's battery is defective.
The fuse has blown.
The 12V device is not
turned on.
The booster battery is not charged.
The 12V device draws more than 15A
or has a short circuit
The battery is bad (will not accept a
charge).
START
PEAK
1V/C
BATTERY
410
2200
CHARGE
CHARGER
Input:100-240V ~ 50/60Hz
Output:17V
0.7A
CABLE LENGTH
GAUGE
28 in./0.71 m
4G
PROTECTION
< 250
MAX HP
• 6 •
REASON/SOLUTION
Check for poor connection to battery
and frame. Make sure connection points
are clean. Rock clips back and forth for
a better connection.
Check the battery charge status by
pressing the button on the front of the
booster. See LED Indicators section of
this manual.
Have the battery checked.
Replace the fuse. (See Section 8.)
Turn on the 12V device.
Check the battery charge status by
pressing the button on the front of the
booster. See LED Indicators section of
this manual.
Disconnect the 12V device. The internal
breaker will automatically reset after a
minute or two. Try the 12V device again.
If it happens again, replace the 12V
device.
Have the battery checked.
278.9 x 95 x 317
POWER OUT
MEMORY
15A FUSE
7.22