Replacing The Lamp; Cleaning And Maintenance; Defrost; Clean - Premium PRF52 Manual Del Usuario

Keep hot foods out of the refrigerator until they are at a natural
temperature, and then place them in the refrigerator.
Avoid keeping the refrigerator doors open for long periods of time.
Wash all food that can be washed (as vegetables) before storing in the
refrigerator.

8. Replacing the lamp

(1). Turn the thermostat to the OFF position "0" and disconnect from the
electrical supply.
(2). Remove all food from the top shelf of the fridge and pull it forward
slightly.
(3). The lamp is located in the back of the thermostat housing. Remove the
plastic cover by pressing the front centre while pulling upwards on the
small rim on the bottom.
(4). Unscrew the lamp in a clockwise direction and screw a new lamp into
the lamp holder in a counterclockwise direction until tight.
(5). Replace the cover pressing firmly.
(6). Set the thermostat to your preferred setting and close the door.
(7). If the power cable is damaged, it should be replaced by an authorized
qualified service representative.

Cleaning and Maintenance

1. Defrost

Freezer must be manually defrosted. When frost is more than 5mm deep,
turn off the appliance and unplug it. As soon as frost is softer, remove it with
care.
1).Power off the refrigerator, open the door and remove all food to a cool
space.
2).Remove the freezer shelf.
3).Remove ice and frost, or let it to melt naturally.
4).Clean the remaining water with a clean soft cloth.
5).Put the food back inside the freezer. Power on again.
Note: if you want to speed up the defrosting process, put a bowl of hot
water on the rack and close the door. Do not use metal tools or electric
heaters to help defrost. That may damage the evaporator.

2. Clean

The inside of the refrigerator needs to be cleaned often.
First, power off the appliance
Then use a soft towel with water or neutral cleanser to scrub away any food
residues and then wipe with a dry cloth.
Note: Do not pour water to the refrigerator exterior walls, since this will
affect the insulation. Do not use hot water, acid, alkali, gasoline, benzene,
caustic cleanser, alcohol, or hard brushes to wipe the plastic parts.

3. How to change the bulb