Johnson Pump SPX Twin Port 12V Manual De Instrucciones página 11

Thru-Bottom Installation
- Install high speed low or high volume water pickup
and either a ball valve or seacock as recommended
by the manufacturer at least 3 to 4 inches below the
water line in an accessible location. Thread intake
of pump into valve and tighten by hand aligning the
discharge port in the direction of the live well. Use
sealing tape or sealant on threads if necessary.
Thru-Transom Installation
– Install thru-hull and ball valve or seacock as recom-
mended by the manufacturer at least 2 to 3 inches
below the water line. Thread pump into valve until
hand tight making sure that the pumps discharge out-
let is orientated between the 10:00 and 2:00 o'clock
position to allow trapped air to vent properly. Use
sealing tape or sealant on threads if necessary.
Live well
Thru-hull
Original instructions
Spraynozzle
Aqua Jet
Wash Down
Pump
TwinPort
11