Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation (continued)
8
Connecting the water supply
lines
Use 1/2 in. I.P.S. faucet connections (2), or use
supply line coupling nuts (3) (not included) with
a 3/8 in. O.D. ball-nose riser (1).
Use wrenches to tighten the connections. Do
not overtighten.
1
Care and Cleaning
This faucet is designed for years of trouble-free performance. Keep it looking new by doing the following:
Clean periodically with a soft cloth.
Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the finish and void your warranty.
Troubleshooting
NOTE: Refer to the service parts section in this manual for
a detailed drawing showing the location of the parts listed
below.
Problem
There are leaks underneath the
handle.
The aerator leaks or has an
inconsistent water flow pattern.
The water will not shut off
completely.
2
3
Possible Cause
The retainer nut has come loose
and the O-ring on the cartridge
is dirty or damaged.
The aerator is dirty or mis-fitted.
The rubber seat and spring is
dirty or broken.
9
Checking for leaks
Turn on the water supply to the faucet.
Use the aerator wrench to remove the aerator
(B) from the faucet (A).
Turn the handles on the faucet (A) and allow
the hot and cold water to run for at least 1
minute to flush out any debris and identify any
possible leaks.
When finished, turn the water off and replace
the aerator (B) with the aerator wrench.
A
B
Tighten the retainer nut.
Clear or replace the O-ring
Remove the aerator and check for
debris in the aerator screens.
Confirm that the rubber washer is
properly installed.
Remove the handle and cartridge to
check the rubber seat and spring.
Clean or replace.
7
Please contact 1-855-434-5224 for further assistance.
Solution
HOMEDEPOT.com/GLACIERBAY
Capítulos
Tabla de contenido
