Recoil Starter; Maintenance And Storage - Husqvarna R 50S Manual Del Operador

Use
1. Do not operate the engine in a confined space
where exhaust fumes (carbon monoxide) can
collect.
2. Use the lawnmower only in daylight or good
artificial light.
3. Avoid operating your lawnmower in wet grass,
where feasible.
4. Take care in wet grass, you may lose your
footing.
5. On slopes, be extra careful of your footing and
wear non-slip footwear.
6. Mow across the face of slopes, never up and
down.
7. Exercise extreme caution when changing
direction on slopes.
8. Mowing on banks and slopes can be
dangerous. Do not mow on banks or steep
slopes.
9. Do not walk backwards when mowing, you
could trip. Walk never run.
10. Never cut grass by pulling the mower towards
you.
11. Stop the engine before pushing the mower
across surfaces other than grass and when
transporting the lawnmower to and from the
area to be mowed.
12. Never operate the lawnmower with damaged
guards or without guards in place.
13. Do not overspeed the engine or alter governor
settings. Excessive speed is dangerous and
shortens lawnmower life.
14. Disengage all blade and drive clutches before
starting.
15. Keep hands and feet away from the cutting
means at all times and especially when
switching on the engine.
16. Do not tilt lawnmower when starting the engine
17. Do not put hands near the grass discharge
chute whilst engine is running.
18. Never pick up or carry a lawnmower while the
engine is running
19. Spark plug wire may be hot - handle with care.
A2-a - handle adjuster
Handle Assembly
1. Your product is supplied with the handles folded
over the product. (A1) Loosen handle adjusters (A2) on both sides of
2.
the product and lift handle assembly up.
3. Adjust handle assembly to the most comfortable
operating position (A3) and tighten handle
adjusters (A2) on both sides of the product

Recoil Starter

1. Disconnect the spark plug lead.
Pull the Operator Presence Control (B1) to
2.
release the brake on the engine.
R 50S AND R 50SE ONLY.
You must release the brake by pulling the OPC
lever to the handle before pulling out the cord.
Safety Precautions
20. Do not attempt any maintenance on your
lawnmower when the engine is hot.
21. Stop the engine, and wait until the blade has
stopped:-
- before leaving the mower unattended for any
period;
22. Release the Operator Presence Control to stop
the engine, wait until the blade has stopped,
disconnect the spark plug lead and wait until
the engine has cooled:-
- before refuelling
- before clearing a blockage;
- before checking, cleaning or working on the
appliance;
- if you hit an object. Do not use your
lawnmower until you are sure that the entire
lawnmower is in a safe operating condition.;
- if the lawnmower starts to vibrate abnormally.
Check immediately. Excessive vibration can
cause injury.
23. Reduce the throttle setting during engine shut
down and, if the engine is provided with a shut-off
valve, turn the fuel off at the conclusion of mowing.

Maintenance and storage

1. Keep all nuts, bolts and screws tight to be sure
the lawnmower is in safe working condition.
2. Check the grassbox/grassbag frequently for
wear or deterioration.
3 Replace worn or damaged parts for safety.
4. Only use the replacement blade, blade bolt,
spacer and impeller specified for this product.
5. Never store the lawnmower with fuel in the tank
inside a building where fumes can reach an
open flame or spark.
6. Allow the engine to cool before storing in any
enclosure.
7. To reduce fire hazard, keep the engine, silencer,
battery compartment and fuel storage area free
of grass, leaves or excessive grease.
8. If the fuel tank has to be drained, this should be
done outdoors.
9. Be careful during adjustment of the machine to
prevent entrapment of the fingers between
moving blades and fixed parts of the machine.
Assembly Instructions
3. Locate cord in the pull cord guide on the lower
handle. (B2)
4. Locate cord in the pull cord guide on the upper
handle. (B3)
Fitting the Grassbox
Lift safety flap. (C1)
1.
Locate grassbox to machine. (C2)
2.
3. Locate safety flap onto the top of the grassbox.
(C3). Ensure the grassbox is securely located.
Please Note :- Ensure no gap remains between the
safety flap and the grassbox
Where grass collection is not required you can use the lawnmower without the grassbox. Ensure the
safety flap is fully closed
ENGLISH - 2