Uline H-8041 Manual De Instrucciones página 6

OPERATING ISSUE
No detergent is delivered.
The suction motor does not
start.
The squeegee does not
clean or has poor suction.
The machine leaves stripes of
wet floor.
The batteries do not provide
the nominal work time.
The battery discharges too
fast during use, even though it
has been charged correctly.
PAGE 6 OF 21
TROUBLESHOOTING CONTINUED
CAUSES
The detergent button LED is off.
The detergent tank is empty.
The brush motor is off.
The hose delivering the detergent
to the brush is blocked.
The detergent tap is dirty or faulty.
The in-line filter is dirty (left side from
operator's position near the wheel).
The fan button LED is off.
The vacuum motor fuse is blown.
The edge of the squeegee blades
in contact with the floor is worn.
The squeegee or hose is blocked or
damaged.
The float switch has tripped (dirty
water drum), is clogged by dirt or
broken.
The suction hose is blocked.
The suction hose is not connected
to the squeegee or is damaged.
Debris is trapped between the
squeegee blades.
Dust or debris on the floor is
catching on the squeegee blades.
Debris is trapped between the
squeegee blades.
The squeegee blades are worn.
The battery charger is not working.
The battery is new and does not
deliver 100% of its expected
capacity.
RECOMMENDATIONS
Press the detergent button.
Fill the detergent tank.
Turn the motor on by pressing the
brush button.
Unblock and open the detergent
tank tap.
Have the detergent tap cleaned or
replaced.
Clean the filter. Make sure to close
the detergent tap prior to cleaning.
Press the fan button.
Replace the vacuum motor fuse.
Replace the squeegee blades.
Unblock and repair the damage.
Empty the recovery tank or reset
the float switch.
Unblock the hose.
Connect or repair the hose.
Clean out debris from the
squeegee blades.
Sweep the floor prior to using the
machine.
Clean out debris from the
squeegee blades.
Replace the squeegee blades.
See battery charging instructions.
This is normal. New batteries require
a break-in period of approximately
10 charging cycles. Unplug unit and
use as normal. Charge after use.
0621 IH-8041