BLACK&DECKER DS321 Manual De Instrucciones página 8

Inversion Stand warnings:
wARNING: Severe abrasion hazard.
• Avoid contacting the rotating belt on the inversion stand with fingers or hands.
• Never use the belt sander in an inverted position without the inversion stand specifically
designed for this product.
• Be sure the belt sander is turned off and not attached to a power source while attaching
to inversion stand. Before re-connecting the tool, depress and release the trigger switch to
ensure that the tool is off.
• When sanding with the belt sander in the inversion stand, hold wood or material being
sanded firmly during operation. The belt may pull the material away from you resulting in injury.
Switch - figure 9 & 10
To start your belt sander, depress the on/off switch as shown in figure 9. To stop your belt
sander release the on/off switch. For continuous operation, depress the on/off switch then
depress the lock-on button (figure 10) and release the on/off switch. To stop your belt
sander, depress the on/off switch to release the lock-on button. Release the on/off switch.
Handy Hints
• Always start your belt sander before it is in contact with the workpiece and do not switch it
off until after it has been lifted from the workpiece.
• Always hold your belt sander with two hands.
• Where possible, clamp the workpiece to a work bench or similar sturdy surface.
• Use the correct grit sanding belt for your application. The following is a suggested list of
belt grits to use with different materials.
Problem
• Unit will not start.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
MATERIAL
Solid Wood
Veneer
Chipboard
Plastics
Steel
Paint Removal
Balsa Wood
Acrylic
TROUBLESHOOTING
Possible Cause
• Cord not plugged in.
• Circuit fuse is blown.
• Circuit breaker is tripped. • Reset circuit breaker. (If the product
• Cord or switch is
damaged.
TOOL CARE AND MAINTENANCE
BELT GRIT
80
150
60/80
100
80 (remove dust bag)
40/60
100
100
• Plug tool into a working outlet.
• Replace circuit fuse. (If the product
repeatedly causes the circuit fuse to
blow, discontinue use immediately
and have it serviced at a Black &
Decker service center or
authorized servicer.)
repeatedly causes the circuit breaker
to trip, discontinue use immediately
and have it serviced at a Black &
Decker service center or
authorized servicer.)
• Have cord or switch replaced at
a Black & Decker Service Center or
Authorized Servicer.
8
Possible Solution