Care And Maintenance - Black and Decker PI100ASB Manual De Instrucciones

PI100ASB_ManualEN_052507.qxp
COOL — Surrounding air temperature should ideally be 10-20°C (50-68°F). Keep the inverter away from direct
sunlight, when possible.
WELL-VENTILATED — Keep the area surrounding the inverter clear to ensure free air circulation around the
unit. Do not place items on or over the inverter during operation. The unit will shut down if the internal
temperature gets too hot. The inverter will auto-reset after it cools down.
SAFE — Do not use the inverter near flammable materials or in any locations that may accumulate flammable fumes or
gases. This is an electrical appliance that can briefly spark when electrical connections are made or broken.

CARE AND MAINTENANCE

Storage
1. Ideal storage temperature range is 0-40°C (32-104°F).
2. Store and use the inverter in a cool, dry place with adequate ventilation for all-around air circulation.
3. Avoid locations that are exposed to heating units, radiators, direct sunlight, or excessive humidity or dampness.
Fuse Replacement (in 12 Volt DC Power Cord)
1. Disconnect unit from 12 volt DC power source.
2. Remove the fuse. You may need to use pliers to do so.
3. Replace with a new fuse (10 amp, blade-type). Refer to the illustration below.
DC POWER CORD
(FROM INVERTER)
Accessories
Recommended accessories for use with your tool are available from your local dealer or authorized service
center. If you need assistance regarding accessories, please call: 1-800-544-6986.
WARNING: The use of any accessory not recommended for use with this tool could be hazardous.
TROUBLESHOOTING
Common Audio/Visual Problems
Problem: Buzzing Sound In Audio Systems
Some inexpensive stereo systems and boom boxes make a buzzing sound when operated from the inverter,
because the power supply in the electronic device does not properly filter the modified sine wave produced by
the inverter. The only solution to this problem is to use a sound system that has a higher quality power supply.
Problem: Television Interference
The 100 Watt Power Inverter with USB Charging Port is shielded to minimize interference with TV signals.
However, in some instances, some interference may still be visible, especially when the TV signal is weak. Try
the following to improve the picture:
1. Move the 100 Watt Inverter as far away as possible from the TV set, the antenna, and the antenna cables.
Use a short AC extension cord, if necessary.
2. Adjust the orientation of the antenna cables, and the TV power cord to minimize interference.
3. Make sure that the antenna feeding the TV provides an adequate (snow-free) signal and that high quality,
shielded antenna cable is used.
Fault LED Lights
When the Power/Fault LED Indicator turns from blue (indicating the unit is powered) to red, a fault condition is
present and the unit will automatically shut down. See the Protective Features Section of this Instruction
Manual and Common Power Output Problems in the following section.
5/25/2007 12:22 PM
12 VOLT DC ACCESSORY ADAPTER
/ AIRPLANE ADAPTER END
FUSE
6
Page 6