Install The Hood - Broan beat K34 Manual De Usario

INSTALL THE HOOD

1. Hang the hood from the brackets through
the rectangular cut-outs on the back of the
hood. Cut-outs are larger than the brackets
to allow for horizontal adjustment.
The bottom of the hood should be 24" to 30"
above the cooking surface.
2. Height adjustment screws provide vertical
adjustment.
3. Depth adjustment screws provide hori-
zontal adjustment.
4. Secure the hood with mounting screws
(4.8x38mm). Use drywall anchors,
provided, if wall studs or framing are not
available.
WIRING
Note: This range hood must be properly
grounded. The unit should be installed by a
qualified electrician in accordance with all
applicable national and local electrical codes.
1. Secure electrical box support with three (3)
screw provided (3.9x9.5mm) and two (2)
washers.
2. Remove the wiring box cover. Remove a
knockout from the wiring box.
3. Secure the conduit to the wiring box
through a conduit connector.
4. Make electrical connections. Connect white
to white, black to black and green to green.
5. Replace wiring box cover and screws. Make
sure that wires are not pinched between
cover and box.
MOUNTING
SCREWS
(4.8x38mm)
DEPTH ADJUSTMENT
SCREWS
HEIGHT
ADJUSTMENT
SCREWS
MOUNTING SCREWS
(4.8x38mm)
SCREWS (3.9x9.5mm)
AND WASHERS
- 6 -
RECTANGULAR
CUTOUTS
MOUNTING
BRACKETS
WALL
FRAMING
ELECTRICAL
BOX SUPPORT
DUCT
CONNECTOR
WIRING BOX COVER