Rowenta ULTRA STEAM Instructivo De Operación página 11

1800128848 DR6015 U1_110 x 154 02/05/13 09:42 Page5
IS THERE
Problems Possible causes
There is no
steam.
The appliance
does not heat.
Water spits.
Water leaks.
The steam
leaves stains
on the fabric.
For any product problems or queries, please visit our website :
www.rowentausa.com
or contact our Helpline on 1-800-ROWENT
nvironment protection first !
Your appliance contains valuable materials which can be
recovered or recycled.
‹
Leave it at a civic waste disposal centre.
PROBLEM ?
The steam brush is
not plugged in.
The water tank is
empty.
You use the
appliance for the
first time.
The steam trigger
has not been
primed.
The water tank is
not in place.
It is not plugged in.
Your appliance is
not hot enough.
You are using
demineralised
water.
The water tank is
not in place.
The water is
leaking from the
stopper.
You are using
water with
additives.
The appliance had
not been cleaned
enough after the
descaling
operation.
5
Solutions
Check that your appliance is correctly
plugged in.
Unplug your appliance and refill the
water tank.
When the appliance is new, press the
steam trigger press the steam trigger
a few times in vertical position.
Press the steam trigger by
successive pressures to begin
steaming.
Ensure that the water tank snaps in
when put into place.
Plug in your appliance.
llow your steam brush to heat for
approximately 50 seconds before
using.
Use tap water or :
50 % untreated tap water,
50 % distilled or demineralised
water.
Be sure that the water tank snaps
when put into place.
Check if the stopper is properly
pushed in place and the tong is
completely inserted in its cavity.
Never add any product in the water
tank.
Read carefully the
Cleaning/Descaling part.
EN
FR
ES