Vorwerk Kobold VB100 Manual De Instrucciones página 89

Fault
The electric brush is not vacuuming
properly.
The Kobold electric brush switches
itself off and the LEDs flash red.
Possible cause and rectification
The suction duct of the electric brush may be blocked.
• Open the inspection flap
electric brush.
• Remove the blockage.
• If necessary, use an appropriate object to do this (e.g.
screwdriver, crochet needle).
• Put the inspection flap
A vacuumed object may be blocking the brushes of the
electric brush.
• Switch off the cordless vacuum cleaner.
• Disconnect the electric brush from the cordless
vacuum cleaner.
• Remove the object.
Threads may be blocking the brushes of the electric brush.
• Cut the threads and remove them as described in chap-
ter "Roller brushes" on page 36.
The carpet may be too dense.
• Briefly lift up the electric brush from the carpet and
place it down on a hard floor.
• Change to 'Brush off' mode on the electric brush as de-
scribed in chapter "Setting the brush mode" on
page 22 and move onto the carpet that is to be
cleaned.
• Alternatively, switch the cordless vacuum cleaner to the
'soft' setting and continue vacuuming the carpet.
on the underside of the
back on.
41