Whittier Wood Products 627W Instrucciones Para Armar página 4

G
D
4) Making sure that the insert in a Back Leg (G) faces toward the center of the desk, carefully glue
the dowels in the back support and one end support into the holes in the Back Leg. Loosely insert
a 3/8" x 2½" Hex Bolt (I) with a Washer (J) through the corner block into the leg. Repeat for the
other back leg. See FIGURES 4 and 4a.
5) Attach the Right Leg (E) and Left Leg (F) in the same manner. When all legs are attached to the
supports and are fl ush against the desk top, tighten the hex bolts securely.
FIG. 5
LL
6) Attach the Cup Pull (LL) to the Drawer (KK) with two #8 x 1" Machine Screws (MM) through the
holes in the drawer front.
7) To eliminate pulling the drawer out too far, attach the Drawer Stop (N) with a #6 x 5/8" Flat Head
Screw (O) to the top.
To determine the location, draw a line between the front edges of both drawer slides. Attach the
drawer stop so that its front edge is 1/2" from the line.
The loose end of the drawer stop may be pressed upwards to install or release the drawer.
Page 4 – 627W
G
FIG. 4
MM
O
KK
AA
N
DRAWER
SLIDE
B
J
I
FIG. 4a
DRAWER
SLIDE
N
O
1/2"
FIG. 6
G
D