Baby Jogger summit X3 Instrucciones De Montaje página 11

FRAME
1 Unpack the pushchair frame from the
box and set the wheels aside.
2 Unfold the pushchair by pulling the
handlebar away from the frame and
pushing towards the floor until the stroller
clicks into place.
3 Place the stroller in the upright
position.
WARNING: Ensure that all the locking
devices are engaged before use.
FRONT WHEEL
4 Installation
• Lay pushchair on its back so the
handlebar is resting on the floor.
• Attach the front wheel by sliding it into
the front wheel mount until it clicks.
Gently pull on the front wheel to make
sure it is properly attached.
5 Removal
• While pressing the front wheel release button, gently slide the front wheel out of
the front wheel mount.
SWIVEL FEATURE
FOR WALKING ON EVEN TERRAIN IN
TRAILING MODE:
6 Gently pull the Swivel Lock into the
upright position until it clicks into
place.
FOR WALKING ON UNEVEN TERRAIN OR
FOR JOGGING:
7 Push the swivel lock button down to lock
the front wheel to a fixed position.
8 Rotate Front Wheel until it clicks into
locked forward position
WARNING:
Seat back must be in the most upright
position.
Front wheel must be locked in jogging
position.
Child must be buckled in the 5 -point
harness.
When loading and unloading child, lock
the front wheel in a fixed position.
ALIGNMENT FEATURE
9 Should the stroller pull to one side
while the Front Wheel is locked in the
fixed position, use the Alignment Knob
to align. If the stroller pulls to the right,
turn the knob left to adjust. If it pulls to
the left, turn the knob right to adjust the
stroller's alignment.
REAR WHEELS
10 Installation
• Align the rear wheel axle with the wheel
mount on the pushchair frame and insert
it into the wheel mount until it locks into
place. You will hear a click.
• Gently pull on the rear wheel to make
sure it is properly attached.
11 Removal
• While pressing down on the wheel
release button, gently slide the rear
wheel out of the wheel mount.
PARKING BRAKE
12 To lock the brakes: push the brake pedal
down to engage the brakes.
13 To release the brakes: lift the brake pedal
up.
WARNING: Lock the parking brakes before
loading and unloading your child and
whenever the pushchair is not moving.
CANOPY
14 Attach the canopy to the frame:
Slide the canopy peg into the top
hole of the Accessory Mounting
Bracket until it clicks into place.
NOTE: Make sure the elastic fabric is
out of the of the Accessory Mounting
Bracket.
15 At the top and on the side of the Canopy,
snap the webbing together around the
top of the frame on both sides.
11
EN