Hergom H-03 Manual De Instrucciones página 14

2.- INSTALLATION
The way the BUILT-IN FIREPLACE H-03 is installed
will decisively affect safety issues and how it
works.
It is important to install the fireplace correctly.
In order to ensure it has been installed correctly,
it should be installed by a professional.
In order to install the Built-in Fireplace H-03, a
chimney ("draw") must be installed using suitable
metal pipes and must extend at least 1 metre
above the highest part of the roof.
If a built-in chimney already exists, the said
chimney must be connected to the Cast Iron
Fireplace by means of a joint and perfected
connected to the smoke outlet on the device.
(See Fig.-2)
It is essential to seal the joints between chimney
sections.
It is advisable to install grilles at the top of the
hood and at the bottom of the lining to allow hot
air to circulate for two main reasons:
- provide extra hot air to the room.
- avoid possible cracks in the lining.
HERGÓM provides 25x20 and 50x20 cm.
ornamental grilles as an option.
3.- LIGHTING AND REGULATING
POWER
LIGHTING UP FOR THE FIRST TIME
Once installed in its final position, check that all
joints have been sealed to prevent outside air
from entering, which would affect the draw.
Before lining the fireplace with bricks or any
other incombustible material, check that it works
correctly.
We recommend a slow fire for 3 to 4 hours when
lighting-up for the first time. This will help
1
Seal
Sellar
2
3
1. Brickwork chimney.
2. Pipe connecting Fireplace to the
chimney
3. Inflow of cool air to the lining
4. Outflow of hot air to the room.
stabilise the different components and avoid any
possible breakages.
It is advisable, when lighting the fireplace for the
first time, to open windows to let any fumes or
odours that may be caused by the combustion of
the protective paint solvents or any other
material to escape.
14
4
Fig. 2