Cleaning Method - Punktal PK-292LIC Manual De Operación

-Depending on the volume and variety of processed foods, users can choose 2 gears from
low to high, that is, low gear with small capacity and easy processing; otherwise, high gear.
- If you want to see the stirring effect halfway, you can rotate to open the small transparent cover,
or you can add fruits, vegetables or water from the small halfway.
- After use, turn the switch knob to "0 stop" (as shown in Figure 7), unplug the power cord to stop
the machine, turn the mixing cup counterclockwise by about 30 degrees, and then remove the cup
(see figure 8) Pour the contents of the cup into the prepared utensil. (Figure 9/10)
- Do not spray water or other liquids during use.
After inserting the drive connector of the lower end of the mixing cup
vertically aligned with the output shaft of the motor base, hold the
handle of the cup to rotate the cup clockwise, and snap the cup into
the lock on the main unit to confirm the installation When the stirring cup
holder presses the safety ejector lever on the host, the safety switch in
the host is touched) (see Figure 5).
- When processing, first turn the knob counterclockwise to "P" for several
times, and then turn the knob to the corresponding "Gear" to process.
Position, if higher speed is needed, turn the switch knob to the "2nd gear"
position. (Figure 6)

CLEANING METHOD

1. Add the right amount of warm water and a small
amount of food detergent when cleaning the mixing
cup, cover the cup cover and turn the switch knob "P"
to run for about 10 seconds (see Figure 11); you can
also immerse the mixing cup in water Brush cleaning.
2. After stirring, turn the switch knob to the "0" position,
unplug the power cord and remove the mixing cup from
the host (see Figure 12), then remove the cup cover
assembly and pour out the water. Use a dry cloth or
towel Dry the blender. (Note: the mixing knife in the
cup is very sharp, be careful to hurt your hands)
3. The main body should be wiped clean with a damp
cloth. Do not rinse with water to avoid damaging the
machine..
12