Panduit KPPTEHB Instrucciones De Instalación

© Panduit Corp. 2015
The KPPTEHB and KPPTMTB Blade Replacement Kits replace the current cutter blade and cutter cap in the event of
reduced performance or excessive wear caused by extended usage. The life cycle of the blade under normal operating
conditions is 100,000 cycles. Follow the step-by-step instructions below:
KPPTEHB:
CONTENTS:
ITEM QTY
1 1
2 1
3 2
4 1
5 1
REPLACING THE CUTTER BLADE: (Refer to figure above)
1. Disconnect air hose from air source and verify that tool does not actuate.
2. Hold tool with nose pointing up, and with thumb holding cutter cap in place.
3. Remove the two [2] low head screws (using 5/64" hex wrench) from under nose of tool and discard. Remove toe clamp
from tool and retain. Next, carefully remove cutter cap and cutter blade from tool and discard.
4. Apply a small amount of Removable Threadlocker (included) to new low head screw threads.
5. Place new cutter blade in position and locate new cutter cap over cutter blade.
NOTE: Sharp edge of cutter blade goes toward cutter cap.
6. While holding cutter cap in place with thumb, position toe clamp over cutter cap. Fasten toe clamp using the two [2]
new low head screws (with Removable Threadlocker applied)
see www loctite com. Tighten screws using 5/64" hex wrench.
E-mail:
[email protected]
EU Website:
www.panduit.com/emea
EU Email:
[email protected]
KPPTEHB / KPPTMTB
PPTEH AND PPTMT BLADE REPLACEMENT KIT
INSTALLATION INSTRUCTIONS
DESCRIPTION
CUTTER CAP
CUTTER BLADE
LOW HEAD SCREWS (8-32" X 3/8")
5/64" HEX WRENCH (NOT SHOWN)
REMOVABLE THREADLOCKER (NOT SHOWN) CA12493A01
www.panduit.com
For MSDS (Material Safety Data Sheet),
Tel: +31 546 580 452 • Fax: +31 546 580 441
Page: 1 of 2
REV: 03 12-2015
PANDUIT PART NUMBER
WH14035C02
WH13685B02
CA12826A01
CAT-12273A-PC
Technical Support:
1-800-777-3300
Panduit Europe • EMEA Service Center
Almelo, Netherlands
PA19745A01