Tabla de contenido
Idiomas disponibles
Idiomas disponibles
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read
the instruction book carefully.
INTENDED USE
The machine is intended for driving in and
loosening screws as well as for drilling in wood,
metal and plastic.
1. CHARGING YOUR BATTERY PACK
WARNING: The charger and battery pack are
specifically designed to work together so do
not attempt to use any other devices. Never
insert or allow metallic objects into your
charger or battery pack connections because
an electrical failure and hazard will occur.
(A) BEFORE USING YOUR CORDLESS TOOL
Your battery pack is UNCHARGED and you must
charge once before use. When you charge the
new battery or one which has not been used for
long periods of time, it may not reach full charge
until after you have discharged it fully in use and
recharge it several times.
(B) CHARGING PROCEDURE (SEE FIG. A)
1) Plug the charger into an appropriate outlet.
The light(a) will be green.
2) Slide the battery pack into the charger, the
light(a) will turn to red to indicate the charging
process has started.
3) When charging is completed, the light(a) will
turn to green. The pack is now fully charged,
unplug the charger and remove the battery pack.
WARNING: When battery charge runs
out after continuously use or exposure
to direct sunlight or heat, allow time for
the tool to cool down before re-charging to
achieve the full charge.
C) CHARGING INDICATOR
This charger is designed to detect some
problems that can arise with battery packs.
Indicator lights indicate problems (see table
A
below). If this occurs, insert a new battery pack
to determine if the charger is OK. If the new
battery charges correctly, then the original pack
is defective and should be returned to a service
center or recycling service center. If the new
battery pack displays the same problem as the
original Battery Pack, have the charger tested at
an authorized service center.
Light
ON/OFF flash
Green flash
Red on
Green on
Red flash
2. TO REMOVE OR INSTALL THE BATTERY
PACK (SEE Fig. B1, B2)
Depress the battery pack release button to
release and slide the battery pack out from your
tool. After recharge, slide it back into your tool. A
simple push and slight pressure will be sufficient.
3.HOW TO USE THE BELT CLIP (SEE FIG.C1
C2)
Screw the Belt clip(5) on the tool with the screw
(not provided). The Belt clip can be hooked on
your belt or pocket, etc.
Status
Charging
Defective
Battery
Fully Charged
Hot/Cold Delay
B1
B2
43
Tabla de contenido
