Tips For Best Results - Remington Heritage MB9100 Manual Del Usuario

página de 129

/ 129
Contenido
Tabla de contenido

Tabla de contenido

INSTRUCTIONS FOR USE

FITTING AND REMOVING FIXED GUIDE COMBS

•

Hook the front of the guide comb over the teeth of the trimmer (Fig. A).

•

Press the back of the guide comb down until it clicks into place.

•

To remove, lift the tab on the back of the guide comb upwards until it comes free from

the trimmer head.

TO THIN AND TAPER THE BEARD/MOUSTACHE

Select the desired comb.

Turn the unit on.

Place the flat top of the trimmer comb against the skin.

Slowly slide through the hair. Repeat from different directions as necessary.

If hair builds up in the trimmer comb during the trimming process, switch the unit off,

pull the comb and brush the hair off.

Note: Use the beard trimmer without the guide combs for trimming hair close to the skin.

This will trim hair to 1mm, holding the blades perpendicular to the skin will trim hair to

0.4mm.

TRIMMING THE NAPE OF YOUR NECK

Note: you will need a hand mirror for this operation if performing it alone.

Remove the guide comb.

Use your fingers to lift the hair at the base of your head up off the neck. Your index

finger should be covering the roots of the hairs you are lifting to prevent accidental

removal by the beard trimmer.

Using your other hand, hold the trimmer to the base of your neck with the cutting unit

facing up and move the trimmer up the length of the neck until it touches your finger

covering the hair roots at the base of your head.

Be sure to move the unit slowly when performing this operation and to keep the roots

at the base of your head out of the way of the trimmer.

TO DEFINE THE BEARD/MOUSTACHE LINE

Hold the trimmer with the trimmer blade facing you.

Start with the edge of beard/moustache line and gently lower the trimmer blade onto

your skin.

Use motions towards the edge of the beard/moustache line to trim to desired locations

in facial area and away from beard in neck area.