Electrical Connection - S&P HCM-150N Manual De Instrucciones

– From the outside, position the exterior grille through the hole in the glass / panel and fi x
into position (from inside) using the grille retaining lugs (4). When in position, twist lugs
around to fi x.
– From the inside locate the fan casing (3) through holes provided for exterior grille threaded
rods (7). Fix the interior plastic nuts (6) onto the threaded rods to secure the fan casing to
the exterior grille. The glass / wall should be sandwiched between the exterior grille and
interior fan casing.
– Wire the fan to the mains electrical supply in accordance with the enclosed electrical ins-
tructions.
– Before switching on the electrical supply, locate the interior grille (1) to the fan casing (3)
and fi x into position by tightening the fi xing screw (5).
MOUNTING THE FAN IN A WALL
– Firstly cut a circular hole in wall in which the fan is to be installed. Cut the hole size in ac-
cordance with the HCM model size as indicated in Figure (A2).
– Figure (B). Remove the interior grille (1) from the fan casing by loosening the fi xing screw
(5).
– Remove the exterior grille (with shutters) by removing the interior plastic fi xing nuts (6).
– Separate the fan casing (3) from the exterior grille (2).
– Position the fan casing against the wall (over cut hole) and mark four screw fi xing positions
through the holes provided.
– Fix the fan casing to the wall with the screws provided.
– Wire the fan to the mains electrical supply in accordance with the enclosed electrical ins-
tructions.
– Before switching on the electrical supply, locate the interior grille (1) to the fan casing (3)
and fi x into position by tightening the fi xing screw (5).
– If required the external grille can be installed as follows:
– Remove the threaded fi xing rods from the external grille.
– Position the external grille against the wall (cut hole) and mark two screw fi xing positions
through the threaded rod holes provided.
– Fix the exterior grille to the wall with the screws provided.

ELECTRICAL CONNECTION

– Before carrying out any installation or wiring of the HCM range, ensure that the mains elec-
trical supply is disconnected.
– Before making any electrical connections ensure that the Voltage and Frequency of the
mains electrical supply matches that of the fan data plate label (maximum permissible
deviation of voltage and frequency +/– 5%).
MAINTENANCE
– Before conducting any maintenance or cleaning of the fan ensure that the unit is disconnec-
ted from the mains electrical supply.
8