Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2 Adjust speed
According to the different work required and the veloci-
ty of the transform tool, the governor from "1" to "6" can
be obtained from low to high, the different speed. (Figu-
re 4)
Effective & safe operation method
Important: it is prohibited to make the polishing opera-
tions without the wheel protective cover, be sure to turn
off the power and let the polishing wheel stop complete-
ly before place the wheel. When working, hold the
tools, turn on the tools switch, and then turn the
polishing wheel to the working surface.
Usually, the polishing wheel and the workpiece surface
to maintain the angle of 15 degrees, only a little force
can, the impact of the general assembly and the impact
of the work quality, and lead to premature wear and
polishing wheel. (Figure 5)
Replacement of electrical brush
It is necessary to replace electrical brush when the tool
has larger spark or does not turn. Use a cross screwdri-
ver to remove the two screws on machine back cover
and remove the machine back cover, remove the round
spring and take out the worn carbon brush, assemble a
new brush and use the hand to confirm free slide in the
slot, return the round spring, assemble the electrical
brush inserter in the corresponding position of brush
supporter. Be sure to replace two brushes simulta-
neously with the original brush. (Figure 6)
9
Keep Working
Tabla de contenido
