Elite EP181 Manual De Usuario página 23

Operating Instructions
Ring handle
To work safety and convenience, use the auxiliary ring
handle. Will assist the protruding part of the annular
handle corresponding to the capsid groove, two holes
in the screw on the inner hexagon screws, and hexa-
gon wrench to tighten,auxiliary ring handle fixed. (Figu-
re 1) Auxiliary ring handle two directions can be insta-
lled.
Install polishing wheel
The polishing wheel on the screw thread and the output
shaft alignment, press the locking cap clockwise rota-
ting polishing machine, until the screw; press the
locking cap, counter clockwise direction of rotation can
be demolition of polishing round. When the wear of the
wool wheel is replaced, the wool wheel must be aligned
with the polishing wheel. (Figure two)
Switch operation
Important: before the plug into the power supply, the
switch must be confirmed that the lock button is loose-
ned, the trigger can reset freely.
1 open and close
Press the trigger, the tool is activated; the trigger is
completely released and the tool is off.. To lock the
switch, press the trigger and press the self lock button,
and the tool will run continuously.. Pull the trigger again
and release completely, and the tool can be turned off
with the lock button state (Figure three).
8
Keep Working