How To Wire Your Ceiling Fan - Fanimation AIREHUG LP7668LBL Manual De Instrucciones

NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from
or to other remote units, simply change the
combination code in the remote and receiver.
1. To set the code on receiver unit, slide dip switches
to the same positions as set on the remote. (Figure 1)
NOTE: Factory setting is all up. Do not use this
position.
WARNING
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
(Figure 2)
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
CAUTION: INCORRECT WIRE CONNECTION WILL
DAMAGE THIS RECEIVER.
2. Connect green wires from ceiling bracket, motor
and ground from supply using wire connector.
Connect black wire from receiver unit marked
"AC IN L" to black supply wire using wire connector.
Connect white wire from receiver unit marked
"AC IN N" to white supply wire using wire connector.
Connect white wire from receiver unit marked
"TO MOTOR N" to white wire from fan using wire
connector supplied with receiver unit. Connect black
wire from receiver unit marked "TO MOTOR L" to
black wire from fan using wire connector supplied with
receiver unit. Lastly, connect blue wire from receiver
unit to the blue fan light wire using wire connector
supplied with receiver unit. (Figure 3)
NOTE: If you feel that you do not have enough
electrical wiring knowledge or experience, have your
fan installed by a licensed electrician.
3. After splicing and making the wire connections, the
wires should be spread apart and turned upward with
the grounded conductor (white), the equipment
-grounding conductor (green) on one side of the
ceiling bracket and the ungrounded conductor (black
and blue) on the other side of the ceiling bracket.
(Figure 3)

How to Wire Your Ceiling Fan

Receiver
Black Wire
from Receiver White Wire
Blue Wire
from Receiver
White Wire
from Supply
Black Wire
from Supply
Black Wire
from Receiver
White Wire
Blue Wire
from Receiver
from Motor
HARDWARE USED:
Wire
Connectors
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors except for the ground wire. Do not operate
fan until the blades are in place. Noise and motor
damage could result.
8
Remote Control
ON DIP
1 2 3 4 5
Dip Switch
Figure 1
Main Fuse Box
Figure 2
Green Wire
from Ceiling
from Receiver
Bracket
BLK_ANT
Green Wire
Black Wire
from Motor
from Motor
White Wire
Figure 3
from Motor
x 6
WARNING
Green Wire
(Ground)
from Supply