Fanimation AIREHUG LP7668LBL Manual De Instrucciones página 10

How to Assemble Your Light Kit or Cap (Continued)
2. Assemble the light kit to the support bracket using
the two key slots in the light kit. Replace the previously
removed screw and securely tighten all three screws.
(Figure 2)
3. Remove one of the three screws in the light kit.
Retain the screw for later and slightly loosen the
remaining two screws. (Figure 3)
4. If installing the light kit, skip this step.
Assemble the light kit wire cover to the light kit using
the two key slots. Replace the removed screw and
secure all three screws. (Figure 4)
5A. (Option A--for use with light kit)
Connect the 2 single pin connectors from the LED
assembly to the 2 single pin connectors from motor
assembly. (Figure 5A)
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
your light kit.
5B. (Option B--for use with steel cap)
If you want to install the steel cap and not the light kit.
Assemble the steel cap to the light kit by twisting in a
clockwise direction. (Figure 5B)
NOTE: If you have installed your fan with the steel
cap, skip steps 6 and 7.
6. Assemble the LED assembly to the light kit using
the two key slots. Replace the removed screw from
Step 3 and secure all three screws. (Figure 6)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
Motor
Assembly
Light Kit
Motor
Assembly
Light Kit
Light Kit
Wire Cover
Figure 5A
Light Kit
LED Assembly
10
Figure 2
Light Kit
Figure 3
Figure 4
LED Light Kit
Assembly
Figure 5B
Figure 6
Steel Cap