Important Information - Product Care; Assembly - I-DRILL 1i-drill Manual De Instrucciones

Important information – Product care
This drill/driver uses Lithium Ion Battery Cells. Care
MUST be taken to ensure both the safety and life of the
pack is maintained. Ensure you have read all of the safety
notes in the previous pages before using the drill/driver.
Treat the battery pack with care and within the guidelines
of this manual. If the pack does become immersed in water
or any fluids, or is subject to a sever drop etc, or it does not
GB
operate within the guidelines of this manual, immediately
STOP using the battery pack and have it checked.
During operation avoid overloading the drill/driver. If
the drill driver is overloaded it will automatically STOP.
Overloading may occur for a number of reasons including
when the drill driver is pushed too hard or when using a
drill bit or attachment greater than what is specified. If you
do overload the drill driver during operation refer to the
"Overload" section in this manual.
Note: When the battery of the drill is at the lower end of the
charge, the drill is more susceptible to the overload condition.
Running the drill at close to maximum load, or continual
resetting of the overload will cause the battery pack to
over heat. When a preset cell temperature is detected, the
battery pack will automatically STOP operating and will not
restart until the battery pack has cooled to a safe level.
In this condition, DO NOT force cool the pack by placing in
a freezer or similar device. Refer to the "Overload" section
in this manual.
Another feature of the drill/battery pack is the low voltage
cut out feature. This feature operates when the voltage
drops below a pre set value. When this occurs the tool will
automatically stop operating. To correct the situation you
need to either insert another charged battery into the drill
or recharge the existing battery, and then proceed with the
drilling/driving application.
Note: Attempting to restart the tool in this condition without
either recharging the battery or installing a battery with
charge will lead to drill restarting and then stopping again
after only a few seconds of operation.
These safety devices have been fitted for the safety,
reliability and life of the tool.

Assembly

WARNING:
• If any part is broken or missing, do not attempt to plug in
the power cord or operate the driver until the broken or
missing part is replaced. Failure to do so could result in
possible serious injury.
• Do not attempt to modify this driver or create accessories
not recommended for use with this driver. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious injury.
• To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
driver when assembling parts.
This product has been shipped completely assembled.
• Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the packing are
included.
• Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
• Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
• If any parts are damaged or missing, please refer to the
numbers listed on the back page of operator's manual.
12