Installing Magicspeed; Tools Required - Dometic GROUP WAECO MagicSpeed MSBE7 Instrucciones De Montaje Y De Uso

Installing MagicSpeed

6 Installing MagicSpeed
6.1

Tools required

For installation and assembly you will need the following tools:
 Drill bit set (fig. 1 1, page 3)
 Electric drill (fig. 1 2, page 3)
 Screwdriver (fig. 1 3, page 3)
 Set of ring or open-ended spanners (fig. 1 4, page 3)
 Set of box spanners (fig. 1 5, page 3)
 Measuring ruler (fig. 1 6, page 3)
 Hammer (fig. 1 7, page 3)
 Centre punch (fig. 1 8, page 3)
To establish and test the electrical connection, the following tools are required:
 Diode test lamp (fig. 1 9, page 3) or voltmeter (fig. 1 10, page 3)
 Insulating tape (fig. 1 12, page 3)
 Sealant
 Cable bushing sleeves (optional)
To fasten the module and the cables, you may need additional screws and cable bind-
ers.
6.2 Installing the control lever
When selecting the installation location, observe the following instructions:
 Make sure the driver does not have to reach through the steering wheel to use the con-
trol lever.
 Install the control lever in a suitable position on the steering column where it can be
safely used at all times.
NOTICE!
A
Before drilling holes, make sure the drill bit will not damage anything on the other
side (fig. 2, page 3).
22
MagicSpeed MSBE7
EN