STERWINS ESH2-45.41 Instrucciones De Montaje, Utilización Y Mantenimiento página 246

FR
2. SAFETY INSTRUCTIONS
ES
included.
PT
g) If the cutting mechanism strikes any foreign objects or if the machine
should start making any unusual noise or vibration, immediately
IT
shut off the power source and allow the machine to stop. Disconnect
the machine from the supply and take the following steps before
EL
restarting and operating the machine:
i) inspect for damage;
PL
ii) replace or repair any damaged parts;
iii)check for and tighten any loose parts.
RU
h) Do not allow processed material to build up in the discharge zone; this
UA
may prevent proper discharge and can result in kickback of material
through the feed intake opening.
RO
i) If the machine becomes clogged, shut-off the power source and
disconnect the machine from supply before cleaning debris.
EN
j) Never operate the machine with defective guards or shields, or without
safety devices, for example debris collector in place.
k) Keep the power source clean of debris and other accumulations to
prevent damage to the power source or possible fire.
l) Do not transport this machine while the power source is running.
m)Stop the machine, and remove plug from the socket. Make sure that all
moving parts have come to a complete stop
- whenever you leave the machine,
- before clearing blockages or unclogging chute,
- before checking, cleaning or working on the machine.
if the machine starts to vibrate abnormally, for immediate check
n) Do not tilt the machine while the power source is running.
246