Troubleshooting; After Sales Service And Spare Parts - Oster Press X press GCSTSG1200 Manual De Instrucciones

WARNING: Do not attempt to pick up the handset while the clean indicator light is
flashing as hot water and steam may be ejected. Only remove from the cleaning tray
once the clean indicator light has stopped flashing and you have switched off the power.
Always use the cleaning tray provided and do not leave unattended during the clean
cycle.
Issue
The iron does not produce steam.
Brown particles are emitted from
the soleplate
No display lights are showing.
For further troubleshooting and FAQs visit www.oster.com.
AFTER SALES SERVICE AND SPARE
In the event that the appliance does not work, but is under warranty, take the unit to the
nearest authorized Oster
Please note that a valid form of proof of purchase will be required.

TROUBLESHOOTING

Root Cause
Water tank level is too low. Your
steam generator will beep twice,
and the power indicator light will
flash to let you know that the
water tank needs filling.
Water tank is not fully inserted to
the base station. Check if power
light is flashing.
If it is on first use the unit may
have not been primed.
The unit is still heating up. The
steam will only operate when the
temperature indicator light is solid.
Check if light is flashing.
The handset needs to be de-
scaled.
Steam generator has not used
steam function for 5 minutes and
entered "Auto Off" mode.
PARTS
Service Center for inspection or repair
®
E n gl is h - 8
Possible solution
Fill water tank.
Remove and re-insert the water
tank until an audible click is heard.
Operate the steam boost a few
times by double-clicking the steam
trigger in quick succession.
Wait until the temperature
indicator light stops flashing and
turns to solid.
Operate the self-clean process.
Follow instructions provided in
"Self-cleaning" section.
Pull the steam trigger. Unit should
come out of "Auto Off" mode.
You may need to wait a short
time for unit to heat up before it
can produce steam. When the
temperature indicator light turns
solid the unit is ready for use.