Kichler 56 Verdi LED Manual De Instrucciones página 8

HANGING THE FAN (continued)
Clevis Pin
Hairpin
Set Screw
Step 3. Carefully feed fan wires and safety cable up through the downrod.
Thread the downrod onto the motor coupling until the clevis pin holes are Hairpin
aligned. Next, replace the clevis pin and hairpin, then tighten both set screws.
Set Screw
Clevis Pin
(Fig. 8)
Motor Body
Step 4. Slip the coupling cover, canopy hole cover and canopy onto the
downrod. Carefully reinstall the hanger ball onto the downrod . Make sure
the cross pin is in the correct position and the set screw is tight and the wires
Fig. 8
are not twisted. (Fig. 9)
Step 5. Now lift the motor body into position and place the hanger ball into
the mounting bracket. Rotate until the "Check Tab" has dropped into the
Canopy
Cross Pin
"Registration Slot " and seats firmly. (Fig. 10) The entire motor body should
Canopy Hole Cover
Set Screw
not rotate if this is done correctly.
Coupling Cover
Downrod
WARNING: Failure to properly seat the "Check Tab" can damage the ceiling
fan during operation.
Fig. 9
Mounting Bracket
Hanger Ball
Registration Slot
Check Tab
Fig. 10
8 | KICHLER.COM