Program Selection - Whirlpool AGB 669/WP Manual De Instalación De Uso

página de 81

/ 81
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

8.3 FIRST DAILY USE (Tank and boiler empty)

Activate the wall switch. Two small illuminated points on the display will turn on; the led indicator on the left of the

switch

will be lit red in order to indicate that the machine is receiving electrical current; Position the

overflow and close the hood.

Press the general power

and the machine begins to fill itself. The

completed it will stop flashing and will remain a steady green

Select the desired washing time by means of the

that upon first use the machine is positioned automatically on a medium cycle

indicator relative to the selected cycle turns on. The led indicator flashes until the end of the wash cycle,

after which it turns a steady green again. To start the cycle, open the hood, insert the basket and close the

hood; the selected led indicator will begin to flash and will stop flashing at the end of the completed cycle.

The display will indicate the wash or rinse temperatures based upon the active function of the machine.

Note: if the machine came equipped with rinse delay, the wash will continue until the programmed rinse

temperature is reached, after which the cycle will terminate. After having selected the continuous cycle

the led indicator

the cycle will terminate once the led indicator

drain pump, remove the overflow and press

turns on, and will terminate with the automatic shutdown of the machine.

PROGRAM

Glasses

Glasses, cups, very dirty plates

Silverware and very dirty plates

Particularly dirty dishes

(*)The cycle durations indicated above are based upon a tri-phase connection with a 50°C hot water

supply.

Where a cold water supply is used, the duration of the cycle could increase in relation to the input water

temperature.

button. The led indicator to the right of the button

will start to flash. To interrupt the cycle press