Emerson CWT-00 Instalacion, Cuidado & Uso página 8

Follow these steps for installing chilled water tank with a cold only faucet.
2
INSTALLING THE COLD ONLY FAUCET
A
Property Damage: Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
B
An assistant may be needed to hold
3
INSTALLING THE WATER TANK
A
Property Damage: All tubes must be cut
B
Property Damage: Do not pinch or break tubing.
Do not distort the last 1 inch of tubing.
Pull on connection to ensure fully engaged.
8
the faucet in place
while securing the base.
Inlet
squarely with no burrs.
Inlet
I I
Unpack faucet components.
I I
On a firm, flat surface, carefully
straighten the copper tubing.
I I
Ensure that the black O-ring is
properly seated in the base of the
faucet (the groove on the underside
of the faucet base).
I I
Feed tube down through sink hole
until the base is at rest.
I I
From under the sink, place the
semi-circular mounting plate onto
the threaded stud.
I I
Place hex nut onto the threaded stud.
Ensure faucet is at desired angle.
I I
Insert screwdriver into hole on side of
hex tool (creating a "T"), and use tool
to tighten nut and secure faucet.
I I
Attach supplied quick connect elbow to
end of supplied white 1/4" tube.
I I
Attach quick connect elbow to water
Inlet on front of chilled water tank.
I I
Measure distance from water inlet on
chilled water tank to water supply
valve (See Step 3). Carefully trim white
1/4" tube, allowing ample slack in tubing.
I I
Attach supplied quick connect elbow to
end of supplied blue 1/4" tube.
I I
Attach quick connect elbow with blue
tube to water Outlet on front of chilled
water tank.
I I
Measure distance from chilled water tank
outlet to water supply line on faucet.
Carefully trim blue tube to correct length.
I I
Using quick connect elbow, connect
blue tube to faucet water supply.