Repair Parts - Flotec FP0S1790PCA Manual Del Usuario

Repair Parts • Troubleshooting
7
6
5
4
3
2
1
Risk of electrical shock and sudden start. Can shock, burn or kill. Can cause electrical shock and person-
al injury. Disconnect electrical power to pump before attempting to troubleshoot or work on it.
Symptom Possible Cause(s)
Pump won't start or run Blown fuse
Low line voltage
Defective motor
Impeller
Pump operates but delivers Low line voltage
little or no water
Something caught in impeller
Small diameter garden hose or long
discharge line
Check valve installed without vent hole
Air lock
Coils or bends in hose
For parts or assistance, call Flotec Customer Service at
Anti-Airlock
Hole
5635 0607
Corrective Action
If blown, replace with fuse of proper size.
If voltage under recommended minimum, check size of wiring from main switch on
property. If OK, contact power company.
Replace pump.
Remove base and screen, locate source of binding.
Call power company.
Clean out impeller.
Use larger diamter garden hose or 1" flexible pipe. Eliminate any excess hose. Short
hoses work best.
Drill a 1/16" - 1/8" (1.6-3.2mm) dia. hole between pump discharge & check valve.
Turn off pump for a few seconds, clean out anti-lock hole and restart pump
Straighten hose.

Repair Parts

Key Part Description
1 Base
2 Screen
3 Shield
4
Impeller
5 Motor
6 90° Garden Hose Adapter
7 Power Cord
NOTICE To purchase a check valve, call Customer Service at
800-365-6832 and order part number PW73-63.
** If motor fails, replace entire pump.
Insert screws through base.
(Base omitted for clarity)
Orientate part number with
anti-airlock hole as shown
Tighten 1st
2nd
3rd
Assemble Screen and Shield as shown.
800-365-6832
4
Qty. Part No.
1 PS70-81
1 PS8-5P
1 PS70-3P
1
PS5-25P
1 **
1 PS74-78
1 PS17-1505
Anti-airlock
hole
5636 0607