Resetting The Thermostat; Additional Operation Features; Auto Changeover Mode - Prostat PRS6110 Manual Del Usuario

Resetting the Thermostat

This thermostat provides you with a reset button that will erase all of your user
settings and programming. The reset feature does not affect the Installer Settings.
To reset the thermostat, use a small object such as a tooth pick or paperclip and
gently press the button located inside the small hole on the front of
the thermostat housing labeled "RESET ".
NOTE: You cannot reset the thermostat if it is locked.

5 Additional Operation Features

Auto Changeover Mode

Auto Changeover mode is a feature enabled/disabled in the Installer Settings
(see Installer Manual). If enabled, it is selected by pressing the SYSTEM button
until AUTO HEAT or AUTO COOL appears in the display.
When Auto Changeover mode is enabled and selected, the system automatically
switches between heating and cooling when the room temperature meets the
programmed heating or cooling set points. To operate properly, the thermostat
requires a "dead band" setting to eliminate program conflicts. The dead band is set
in the Installer Settings (See Installer Manual). The default setting is 3°F. Therefore, you will not be able to set
your heat or cool temperature within 3° F of each other. If a setting is made in either heating or cooling which
violates the dead band, the opposite mode will adjust up or down automatically to maintain the programmed
dead band spacing.
User Manual 22
INST