Uline H-738 Manual De Instrucciones página 2

1. Thread the strap through the seal and around the
bundle. Thread the strap through the seal again.
Bend the lower strap sharply to hook the lower lip of
the seal, then pull the slack out of the strap.
(See Figure 1)
Figure 1
2. Squeeze the handles together to lift the feed-wheel.
Insert the strap into the breaker nose slot and push
the tool up against the seal. (See Figure 2)
Figure 2
3. Stand to one side of the strap line. Tension the strap
by raising and lowering the tension handle.
(See Figure 3)
Figure 3
PAGE 2 OF 6
OPERATION
4. When desired tension is reached, push the drive
pawl forward and lower the tension handle until it
contacts the lift arm. (See Figure 4)
Figure 4
5. Use a single notch sealer to seal the joint.
(See Figure 5)
Figure 5
6. Break off excess strap at the seal. Raise the tool
perpendicular to the seal, then lower it. (See Figure 6)
Figure 6
WARNING! Inspect the tool daily and replace
worn or broken parts. Tool operation can be
affected and result in serious personal injury.
1-800-295-5510
uline.com
0621 IH-738