Uline H-7866 Guia De Inicio Rapido

H-7866, H-7867
GARAGE TOOL HOLDER
TOOLS NEEDED
Drill
Drill Bit (Optional)
Mounting Bracket Mounting Bracket Clip
(2 for H-7866)
(3 for H-7867)
Locate studs and align the mounting template.Balance
with the level and mark the holes using the template.
(See Figure 1)
NOTE: Holes in the mounting template have
16" spacing to accommodate U.S. stud
configuration.
NOTE: If not planning to drill into a stud,
pre-drill holes in wall using a drill bit that is
slightly smaller than wall anchor. Insert wall
anchor into hole.
PAGE 1 OF 6
1-800-295-5510
uline.com
Level
Pencil
End Cap x 2
(2 for H-7866)
(3 for H-7867)
Aluminum Rail x 1
Figure 1
PARTS
Wall Anchor (Optional)
(2 for H-7866)
(3 for H-7867)
ASSEMBLY
1. Screw each mounting bracket
into the wall. (See Figure 2)
NOTE: Do not overtighten.
2. Install the end caps on the aluminum rail by
snapping them firmly into each end. (See Figure 3)
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Screw
(2 for H-7866) (3 for H-7866)
(3 for H-7867)
Mounting Template x 1
Holder
(5 for H-7867)
Figure 2
Figure 3
0521 IH-7866