Clock Setting; Radio Operation - Sangean WR-3 Instrucciones De Manejo

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

Clock setting

You will need to set the clock before the alarm function can be set.
1. Press and hold the TIME SET button (either UP or Down), until
the minute digits on the display flash, then release the button.
2. When the minute digits are still flashing, press the TIME SET UP
or DOWN button
* Press TIME SET button once for 1 minute, press and hold to
make the adjustment run faster to change the hour digits.
3. Without touching the buttons for 7 seconds, the time will be set
and the time digits will stop flashing.

Radio Operation

FM/MW (AM) operation
1. Switch on your radio by pressing the On/Off button on the
remote control or by pressing the Control knob on the radio.
2. Press and release the RADIO button until "FM" or "MW" (AM)
shows on the display and the radio will enter the FM or
MW (AM) mode.
3. Press the SEEK UP or DOWN button
scan for the next active frequency. Or, press the TUNE UP or
DOWN button
frequency, until the active frequency is found.
* 1 FM step = 50 kHz or 100 kHz
1 MW (AM) step = 9 kHz or 10 kHz
4. Adjust the Volume by pressing VOLUME UP or DOWN button on
the remote control, or by rotating the control knob on the radio.
5. Adjust 3D Sound switch to the required settings.
(on the back panel)
6. To switch off your radio press the On/Off button.
7
to the desired time is set.
to select a higher or lower a step of
and the radio will
Tabla de contenido
loading

Tabla de contenido