Transporting; Environmental Protection - Stiga Villa 2WD Serie Uso Y Mantenimiento

EN
Wear suitable
handling the cutter blade assy during
removal and reinstallation operations
Check the cutting blade's balance after
sharpening All operations concerning
the cutting deck assy (disassembling,
sharpening, balancing,
and/or replacement) are tough works
and require a specific knowledge as
well as special tools; for sake of safety,
they should always be performed by an
authorized service centre
• Regularly check the brakes work properly.
It is important to service the brakes and
repair them if necessary.
• Frequently check the grass collector for
wear and damage.
• Replace any damaged warning and
instruction stickers.
• If the machine has no mechanical
stoppers for transport, accessories must
always be resting on the ground when
the machine is parked, stored or left
unattended.
• Store the machine where children cannot
get to it.
Never store the equipment with fuel
in the tank inside a building where fu-
mes may reach a flame or a spark or a
source of extreme heat
• Allow the engine to cool before storing in
an enclosed space.
• To reduce the fire hazard, keep the
engine, exhaust silencer, battery
compartment and fuel storage area free of
grass, leaves, or excessive grease.
• To reduce the risk of fire, regularly check
the machine for oil and/or fuel leaks.
• If the fuel tank has to be drained, this
should be done outdoors and when the
engine is cool.
• The ignition key must never be left
inserted in the machine, or where children
or persons not familiar to the machine may
reach it. Before any maintenance or repair,
remove the ignition key.
CAUTION! – Battery acid is corrosive
In the event of mechanical damage or
overcharging, acid may leak out Avoid
inhalation or contact with any part of
the body
10
work gloves when
assembling
ENGLISH
(Translation of the Original Instructions)
Inhaled acid fumes are harmful to mu-
cous membranes and other internal
organs Seek medical attention imme-
diately
CAUTION! – Do not overcharge the bat-
tery Excessive charging may cause the
battery to explode with subsequent
acid leaks
CAUTION! – Acid can seriously damage
tools, clothing and other materials Rin-
se away spilled acid immediately with
water
Do not short circuit the battery termi-
nals Sparks occur which can result in
fire.
TAKE CARE over the hydraulic compo-
nents. Pressurized hydraulic fluid leaks
may lead to injection injuries which can
seriously damage tissues and need im-
mediate medical attention
3 5

TRANSPORTING

CAUTION! - If the machine is transpor-
ted on a truck or trailer, use ramps with
suitable resistance, width and length
Load the machine with the engine
switched off, without a driver and
pushed by an adequate number of pe-
ople
During
stopcock (if fitted), lower the cutting
deck assy or the accessory, engage the
parking brake and fasten the machine
securely with ropes or chains to the
hauling device
3 6

ENVIRONMENTAL PROTECTION

• Safeguarding the environment must be a
relevant and priority aspect of machine use, of
benefit to the community and the environment
we live in. Avoid being a disturbance to the
neighbourhood.
• Adhere strictly to the local regulations governing
the disposal of packaging, oil, fuel, filters,
damaged parts or any other element which may
have an impact on the environment; this waste
should not be disposed of along with standard
household waste, but must be disposed of
separately and sent to special waste disposal
facilities for handling and recycling.
transport, close the fuel