Cutting Height; Cutting Marker - Nogueira SDN-170A Manual De Instrucciones

Cutting height

Place the mower connected to the tractor on a flat place and then proceed as follows:
Lift the mower using the hydraulic system, until the cutting bar is approximately 30 cm from the ground
(fig.12).
Using the remote controller value on the tractor, activate the piston in the machine and lower the
cutting bar until it is 10 cm from the ground (fig.12).
Now, activate the hydraulic system in the tractor and lower the mower, until the connecting pins are 40
to 45 cm above the ground (fig.13).
SHORTENING THE ARM: FOR CUTTING LOWER.
LENGTHENING THE ARM: FOR CUTTING HIGHER.
fig.12

Cutting marker

As the mower performs it cutting work, the marker forms a small furrow to show the area which has
already been cut. Spring A on the marker can be adjusted, for increased or decreased tension, based
on the conditions of the product being harvested.
If necessary, the wooden shaft B can also be repositioned, by changing the assembly position of the
fastening holes.
fig.14
SDN-170A
fig.13
fig.15
15