Connecting Your Cuff; Placing Your Cuff On Properly - AND Life Source UA-704 Guía De Instrucciones

Ocultar thumbs Ver también para Life Source UA-704:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

CONNECTING YOUR CUFF

Once you have selected the correct air connector plug, refer to the
drawings below and complete the following steps:
1 .
Insert the cuff tube end of the air connector plug into the cuff
tube.
2 .
Insert the
monitor end of
the air connector
plug into the
digital blood
pressure monitor
air socket. You
will hear it snap
into the monitor.
NOTE: For UA-704 / UA-705 models, insert the bulb tube end of the air
connector plug into the bulb tube . The bulb and cuff tube ends of the
T-Connector plug are interchangeable .
3 .
When these connections
have been made, your blood
pressure monitor is ready
for operation.
NOTE: Refer to the Instruction
Manual that was included with your
monitor for operation information
LifeSource Health Line (Toll-Free): 1-888-726-9966
E-4
Before you place the cuff on your arm:
SYSTOLIC DIASTOLIC (PULSE)
DIGITAL BLOOD PRESSURE MONITOR
MEASURING
POWER
PRESS EXHAUST
RE-MEASURE
BATTERY LOW
RE-MEASURE
SYSTOLIC
mmHg
DIGITAL
DIASTOLIC
Now you are ready. Follow these simple steps:
BLOOD
mmHg
PRESSURE
MONITOR
PUL / min
1 .
SYSTOLIC
mmHg
2 .
DIGITAL
DIASTOLIC
BLOOD
mmHg
PRESSURE
MONITOR
PUL / min
3 .
4 .
LifeSource Health Line (Toll-Free): 1-888-726-9966

PLACING YOUR CUFF ON PROPERLY

Relax for about 5 to 10 minutes before measurement.
Remove constricting clothing and place cuff on bare arm.
Unless your physician recommends otherwise, use left arm to
measure pressure.
Sit comfortably with your left arm resting on a flat surface
so that the center of your upper arm is at the same height as
your heart.
Lay left arm on the table with palm up.
(For cuffs with a metal D-Ring, thread
cuff end through metal loop, smooth
side against arm). Position the tube
off-center toward the inner side of arm
in-line with the little
finger.
Fasten the cuff securely. (To fasten cuffs
with a metal D-Ring, pull the end of
the cuff to tighten it and fold back the
extra material). The cuff should be snug but
not too tight. You should be able to insert
two fingers between the cuff and your arm.
Refer to the instruction manual that was
included with your monitor for information
on how to use your blood pressure monitor.
Cuff with
D-Ring
All Cuffs
Tube
E-5

Capítulos

Tabla de contenido
loading

Tabla de contenido