Tabla de contenido
Eng
1. Lower flange of mower deck
2. Left rear lift link
3. Upper trunnion nut
4. Rear lift link trunnion
5. Lower trunnion nut
"B"
1
2
"C"
3
4
5
• Measure distance from ground to lower flange of mower
deck on both sides of mower (dim. "B" & dim. "C"). Dim.
B and C should be the same.
• Level the mower side-to-side by adjusting the left rear lift
link. To raise left side of mower, loosen upper trunnion nut
and tighten the lower trunnion nut. To lower left side of
mower, loosen lower trunnion nut and tighten upper trunnion
nut.
NOTE: One rotation of lower trunnion nut is equivalent to
approximately 1/8 inch of height change. Be sure both
trunnion nuts are tightened against trunnion after adjust-
ment.
Level mower front to rear
• For best cutting results, the rear of the mower should be
1/4 to 3/8 inch higher than the front of the mower. Measure
distance from ground line to lower flange of deck at right
front and right rear (dim. "D" & "E") in line with front and
rear tires.
• Raise or lower rear of mower housing by adjusting right
rear lift link. To raise rear of mower housing, loosen upper
trunnion nut and tighten lower trunnion nut. To lower rear
of mower housing, loosen lower trunnion nut and tighten
upper trunnion nut.
"E"
1. Lower flange of mower deck
2. Right rear lift link
53
1
2
"D"
5
Tabla de contenido
