3. Ceiling Fan Assembly
3.8
Retighten the Two Phillips Head Set Screws evenly to
secure the Downrod to the Motor Coupler in a vertical
position (Figure 8) .
WARNING
!
It is critical that the set screws in the motor coupler are
securely tightened. Failure to verify that the set screws
are properly installed could result in the fan falling.
3.9
Make sure the Grommet is properly installed in the
Coupler Cover, then slide the Coupler Cover on the
6" Downrod until it rests on the Motor Housing (Figure 9) .
3.10
Place the Ceiling Cover over the Downrod (Figure 10) .
Be sure that the Ceiling Cover and the Coupler Cover
are both oriented correctly (Figure 10) .
(Continued)
DOWNROD
RETIGHTEN
PHILLIPS HEAD
SET SCREWS (2)
Figure 8
DOWNROD
MOTOR
HOUSING
Figure 9
DOWNROD
Figure 10
8
MOTOR COUPLER
GROMMET
COUPLER
COVER
CEILING COVER
ETL Model No.: CF315