Pump Performance - Smartpond DP700UV Manual De Instrucciones

Step 2. Adjust the flow
control to the lowest setting.
Once the pump has been
turned on (after step 4) you
may adjust the flow control
to the preferred setting.
Step 3. Place the pump
inside the pumpshield
Pull the drawstring until the
pumpshield
®
around the tubing and
power cord, and tie a knot to
secure.
Step 4. Place the pump into
the water and connect to a
properly grounded electrical
outlet.

PUMP PERFORMANCE

Pump Specifications
Max Flow Rate
685-GPH at 1-ft height
Max Pumping Height
11.5-ft (0-GPH)
Power Consumption
50-watts / 0.85-amps
UV Specifications
Ballast Input Voltage
12-volts
Lamp Power
2.5-watts
UV Irradiance
1700 μ W/cm
Bulb Life
10,000 hours
MAINTENANCE
Before cleaning, always disconnect the pump from the power
source. Untie the drawstring on the pumpshield
remove the pump from the pumpshield
then place the pump back inside the pumshield
pump.
NOTE: If the pump performance is still unsatisfactory, proceed
to the next page.
4 VISIT WWW.SMART-POND.COM FOR PRODUCT INFORMATION AND TIPS.
.
®
is fully closed
2
2
GFCI outlet
FLOW RATES (GPH)**
10 110
9 185
8 270
7 345
6 405
5 465
4 520
3 575
2 635
1 685
0 745
PUMP
**See P.12 or P.20 for metric data
®
. Clean the pumpshield
®
®
3
4
and then
®
and test the