Smartpond 52688 Manual De Instrucciones página 9

Step 10. Turn over the cover and
place the o-ring into the groove
at the lip of the inside edge.
The o-ring should be laid evenly
without any twists or kinks to
insure a water tight seal.
Step 11. Place the assembled
cover with the o-ring onto the tank.
Step 12. Latch the clamps.
Step 13. Assemble tubing
back onto pond filter before
reconnecting to the power source.
To maximize the performance of the UV clarifier, periodically
disassemble the filter to clean dirt and debris from the exterior of the
glass tube and inside light housing.
Check the UV bulb to make sure that it has not burned out. Replace
the bulb as necessary, or after every season.
Step 1. Disconnect the
filter from the outlet. Allow
a sufficient time to pass
for the light to cool before
disassembling the light.
Step 2. Use a screwdriver
to remove the two screws
that hold the cap in place
and remove the cap by
using the handles.
Step 3. Use a screwdriver
to remove the two screws
that hold the wire clip in
place and remove the wire
clip.
Step 4. Rotate the locking
ring counterclockwise to
remove the lamp holder.
Step 5. To replace the
bulb, remove the bulb
holder. Carefully remove
the old bulb by pull firmly
on the base. Carefully install the new bulb and put the bulb holder back
in place.
PLEASE CALL CUSTOMER CARE BEFORE RETURNING ITEM TO LOWE'S: 1-888-755-4497
11
2
4
12
13
3
5
7