Tabla de contenido
P
x 16
T
S
FIG. 8
8. Attach Locking Casters (S) on front legs (B & C) using Screw (P) into the pre-drilled holes
in bottom of the legs. See FIGURE 8. Attach the other two Casters (T) on the back legs (A)
using Screws (P) into the pre-drilled holes in the bottom of the legs.
U
x 4
V
x 4
U
FIG. 9A
READ CAM LOCK SYSTEM INSTRUCTIONS NOW.
9. Insert four Cam Connectors (U) in the Drawer Front (H). Attach Left Drawer Side (I) and
Right Drawer Side (J) to Drawer Front (H) with four Cam Housings (V). Make sure that the
Cam Housings are facing out from the drawer and the grooves for the drawer bottom match.
Tighten cams housings. Slide the Drawer Bottom (K) into the grooves. Attach the Drawer End
(L) to the sides using Screw (W) as shown in FIGURE 9A.
Square the drawers by measuring from left front to right rear and from right front to left rear.
The measurements should be equal. If one is longer, hold the drawer by the corners on the
longest line and squeeze them together until square. See FIGURE 9B.
Page 6 – 203W
P
P
T
W
x 4
V
W
V
W
P
T
S
U
W
W
P
P
P
S
FIG. 9B
P
P
Tabla de contenido
